Film Clips
Removing the Port Crankshaft for
machining - Thursday March 06, 2008. by Colin
Brogan
Hosted on You Tube
March 09, 2008
Removing the Port Crankshaft for
machining - Thursday March 06, 2008. by Colin
Brogan
Hosted on You Tube
March 09, 2008
100_1557.mov General
service pump test run March 03, 2007
100_1495.mov Work in
progress on January 09, 2007 January 17, 2007
100_1449.mov
Removing the Pistons: Heat is applied to the port Low Pressure cylinder December 05, 2006
100_1401.mov
Removing the pistons: Starboard main engine.
'A little 'shock treatment' is applied,
after heating in the hope of expanding the piston a fraction, a whack
with a hammer should do the trick, not today though!!
December 05, 2006
Registered
Charity: 1104681 
